Launch to JIC Fittings

Introduction:

JIC Fitting what is alpilean a selection of hydraulic fittings that’s made in accordance to the SAE J514 standards. The acronym JIC stands for Joint Industry Council. It’s also known as the JIC thirty seven degrees flare fitting as it’s a 37 degrees flare seating area. These fittings are utilized on oil hydraulic methods in fields which are a lot of (gas delivery, etc…), mobile hydraulic equipment, shipbuilding, fuel power application. A JIC fitting system has three parts that create a tubing assembly: installing, flare nut, and sleeve.

Material:

Materials used-to fabricate JIC fittings include stainless-steel and carbon steel SS316L.

Sizes:

JIC body and flare nut are obtainable in exterior diameter («OD) sizes between 1/8″ to 1 2». Sleeve has 2 different reading measurements, metric measurement (mm) and inch exterior diameter («OD). Sleeve size can be bought from 3mm to 50mm as well as 1/8″ to 2». Fitting sizes are specified by the corresponding outside diameter of the tubing for the numerous kinds of tube ends.

Functioning Pressure:

The conventional functioning strain of the fittings ranges from thousand to 5000 psi for different sizes & connections. The minimum burst stress is 4 times the working strain. The JIC fittings must be able to withstand twice the working stress for a period of one minute without leakage or failure.

Remember to take note that the strain rating of an exact same fitting could vary when it is connected to various equipments.. For instance, if a fitting with a minimal performing pressure is attached to a pipe, it will result in a general much reduce functioning pressure. In all cases, always take into account the lowest pressure as the optimum working pressure of the system.

So how does a JIC fitting works: For tube connections, the assembly operation starts out of the preparation of the hose. For starters, the nut and sleeve are inserted onto the end of a hose. With the use of a flaring tool, form the end of the conduit to thirty seven degrees. Next, tighten the nut by using a spanner until the nut is tight and the sleeve grips onto the tube. If the fittings are bench assembled, the gripping measures might be driven by revolving the tubing by hand as the nut is pulled down. When the tube might no longer be rotated by hand, the sleeve has gripped onto the tube. Once this happens,, firm up the nut by switching it one complete turn. This may vary somewhat with various tubing materials, but for basic practice, it’s an excellent rule to follow.

Configurations of JIC Fitting: Commonly used connection sorts be made up of: JIC/BSPP Male Connector, JIC/ NPT Male connector, JIC union, JIC/NPT Swivel Male Connector, JIC/BSPP Swivel Male Connector.

Brand of JIC Fittings:

HS Corporation is a Korean manufacturer specializing in JIC Fitting. Started in 1980, HS Corporation has over thirty years of specialised experience in manufacturing fittings.